Loading ...
Loading ...
Loading ...
ENGLISH
FOAM SLEEVE
16
INSTALLATION AND CLEANING:
29. With tank cover in an upside down position, slide foam
sleeve
16
down over lid cage pulling until foam sleeve
16
completely covers lid cage. Fig. 14.
WARNING:
TO CLEAN THE FOAM
SLEEVE, DISCONNECT THE PLUG FROM THE
WALL OUTLET. REMOVE THE TANK COVER
AND PLACE THE COVER IN AN UPSIDEDOWN
POSITION. REMOVE FOAM SLEEVE BY SLIDING IT
UP AND OFF THE LID CAGE.
30. Shake excess debris off of the foam sleeve
16
with a
rapid up and down movement.
31. Hold foam sleeve
16
under running water for a minute
or two, rinsing from the inside of the filter. A water wash
is not always required, depending on the condition of the
foam sleeve.
32. Check the filter
16
for tears. If any are found, replace with
a new filter
16
.
BLOWER FEATURE
33. Your vacuum can be used as a powerful blower. To use
the blower feature
3
, clear the hose of any debris or
obstructions. Insert machine hose
12
end into blower
port
3
located on the back of the tank cover. Twist
the hose end slightly to tighten the connection. Fig.
15. Caution should be used when using as a blower
due to the powerful force of air when using certain
attachments.
WARNING: ALWAYS WEAR EYE
PROTECTION TO PREVENT ROCKS OR DEBRIS
FROM BEING BLOWN OR RICOCHETING INTO THE
EYES OR FACE WHICH CAN RESULT IN SERIOUS
INJURY.
EMPTYING LIQUID WASTE FROM THE TANK
34. To empty liquid waste from the tank, turn the vacuum off
and remove the plug
7
from the wall outlet. Remove
the tank cover and deposit the liquid waste in a suitable
drain. After tank is empty, return the tank cover to its
original position.
AUTOMATIC SUCTION SHUT-OFF
35. The vacuum is equipped with an automatic suction
shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises
until it seats itself against a seal at the intake of the
motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise and
the suction is drastically reduced. If this occurs, turn unit
off immediately. Failure to turn unit off after float rises
and shuts off suction will result in extensive damage to
the motor. To continue use, empty the liquid waste from
the tank as outlined in the previous section.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE VACUUM COULD
LOSE SUCTION. IF THIS OCCURS, TURN UNIT OFF AND PLACE
VAC IN UPRIGHT POSITION. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU WILL BE ABLE
TO CONTINUE OPERATION.
LUBRICATION
36. No lubrication is necessary as the motor is equipped with
lifetime lubricated bearings.
TOOL STORAGE
37. Set tank cover onto the tank. Position back of tank facing
you.
38. Take tool holder
18
and slide over notches located on
rear of tank. Fig. 16.
HOSE STRAP
10
39. Wrap hose strap Fig. 17 around hose
12
aligning raised
areas on back of strap into a groove on hose Fig. 18.
Fig. 14
7
Fig. 16
Fig. 15
Loading ...
Loading ...
Loading ...