Loading ...
Loading ...
Loading ...
5
Safety Warnings
English
20. Never push objects of any kind into this
product through openings as they may touch
short-out parts or dangerous voltage points
that could result in a fire or electric shock.
21. If an outside antenna is connected to the
television equipment, be sure the antenna
system is grounded so as to provide some
protection against voltage surges and built
up static charges. Section 810 of the National
Electrical Code provides information with
respect to proper grounding of the mast and
supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of
grounding conductors, location of antenna
discharge unit, connection to grounding
electrodes, and requirements for the
grounding electrodes.
22. An outside antenna system should not be
located in the vicinity of overhead power
lines or other electrical light or power circuits,
or where it can fall into such power lines or
circuits. When installing an outside antenna
system, extreme care should be taken to keep
from touching such power lines or circuits as
contact with them might be fatal.
NEC-NATIONAL
ELECTRICAL
CODE S2898A
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H))
GROUND CLAMPS
GROUND CLAMP
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
EXAMPLE OF ANTENNA GROUNDING AS PER
THE NATIONAL ELECTRICAL CODE
ANTENNA
LEAD IN WIRE
GROUNDING
CONDUCTORS (NEC
SECTION 810-21)
ELECTRIC SERVICE
EQUIPMENT
23. NOTE TO CABLE/TV INSTALLER: This
reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the
National Electric Code (U.S.A.). The code
provides guidelines for proper grounding and,
in particular, specifies that the cable ground
shall be connected to the grounding system of
the building, as close to the point of the cable
entry as practical.
24. When replacement parts are required, be sure
the service technician uses replacement parts
specified by the manufacturer or those that
have the same characteristics as the original
part. Unauthorized substitutions may result in
fire, electric shock or other hazards.
25. Upon completion of any service or repairs to
this unit, ask the service technician to perform
safety checks to determine that the unit is in
proper operating condition.
26. When you connect the product to other
equipment, turn off the power and unplug
from the wall outlet. Failure to do so may
cause an electric shock and serious personal
injury. Read the owner’s manual of the
other equipment carefully and follow the
instructions when making any connections.
27. The socket-outlet must be installed near the
unit and easily accessible.
28. Where the mains plug is used as the
disconnect device, the disconnect device
shall remain readily operable.
29. Never remove the back cover of the TV as
this can expose you to very high voltages
and other hazards. If the TV does not
operate properly, unplug the TV and call
your authorized dealer or service center.
Adjust only those controls that are covered
in the instructions, as improper changes or
modifications not expressly approved by
Furrion could void the user’s warranty.
30. Do not submerge this TV in water or pressure
wash it. It is not designed to be submerged
in water, withstand pressure washers,
high-pressure water jets, or hurricane-type
weather.
31. Cleaning : With your TV turned off, gently
wipe the surface of the display panel with a
damp (with water) microfiber, cotton or flannel
cloth. (Do not use tissues, rags, sponges or
paper towels because they may damage the
screen and leave lint pieces behind). Remove
any dirt and salt deposits from the unit, being
careful to rinse the cloth frequently to avoid
scratching the TV or screen surface. Avoid
using harsh chemicals, abrasives, or solvents
when cleaning any surface on the unit.
Loading ...
Loading ...
Loading ...