Loading ...
Loading ...
Loading ...
12
1.
1
B
J
Knobs
I
Locate two canopy mounting screws (J) on
underside of mounting bracket (C) and remove
canopy mounting screw (J) closest to the open end
of the mounting bracket (C). Partially loosen the
other canopy mounting screw (J). Lift canopy (B) to
mounting bracket (C). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (J) and push up. Twist canopy (B) to lock.
Re-insert canopy mounting screw (J) that was just
removed, then securely tighten both canopy
mounting screws (J).
Slide canopy cover (I) up to canopy (B), aligning
knobs on canopy cover (I) with openings in bottom
of canopy (B). Press up gently but firmly on the
canopy cover (I) until it fits into the bottom of the
canopy (B) and then turn canopy cover (I) clockwise
about 1/2 in.
FINAL INSTALLATION
2.
Remove three preassembled switch housing
screws (M) from switch housing plate on underside
of motor housing (D). Connect male plug from
motor housing (D) to female plug from switch
housing (F), matching up the colors on the male
plug with the colors on the female plug for the
correct fit. Make sure plugs are connected
completely.
Align holes in switch housing (F) with holes in
switch housing plate. Re-insert previously removed
switch housing screws (M). Tighten all switch
housing screws (M) securely.
Switch
Housing
Plate
2
WARNING: RISK OF SHOCK. The plastic that
holds the molex connections together inside the
switch housing (F) should not be removed. The
molex connections should not be used unless a light
kit will be immediately installed. The power should
be turned off before removing plastic from molex
connections and prior to light kit installation.
NOTE: If you purchased a compatible light kit, refer
to the instructions provided with the light kit
purchased to complete the installation.
Yoke
D
F
M
M
M
Male Plug
Female Plug
Loading ...
Loading ...
Loading ...