Loading ...
Loading ...
Loading ...
5
Location Requirements
Keep flammable
materials and vapors, such as gasoline, away
from appliances. Failure to do so can result in fire, explosion or
death.
Location:
IMPORTANT:
Do not install the appliance near an oven, radiator, or other heat
source, nor in a location where the temperature w
ill fall below 40°F (5°C). Do not
place in direct sunlight.
Check the strength of the floor before installing your appliance. It should hold the
weight of a fully loaded appliance. Allow at least 4” (10
cm) of airspace at the top
and on both sides of the appliance and also 4
” between the back of the appliance
and the wall. If the appliance is going to be placed next to
a wall, leave extra
space on the hinge side so the door can open wider than its width.
NOTE: Allow 4” (10
cm) clearance at the top and sides and a ¼” (0.64 cm)
clearance between appliances.
IF YOUR MODEL HAS THE LETTERS “BI”
IN THE SUFFIX, IT IS DESIGNED FOR BUILT-IN USE
AND REQUIRE
ONLY
MINIMAL
CLEARANCES EXCEPT AT THE BACK
WHERE AT
LEAST 2” OF CLEARANCE SHOULD BE ALLOWED.
Electrical Shock Hazard
•
Plug into a grounded 3-prong outlet.
•
Do not remove ground prong.
•
Do not use an adapter.
•
Do not use an extension cord.
Failure to follow these instructions can result in fire,
electrical shock or
death.
Recommended grounding method:
A 115 Volt (AC only) 60 Hz grounded electrical supply with a 15-
or circuit breaker is required. It is recommended that a separate circuit serving
only your appliance be provided. Use
outlets that cannot be turned off by a
switch or pull chain. Do not use an extension cord.
materials and vapors, such as gasoline, away
from appliances. Failure to do so can result in fire, explosion or
Do not install the appliance near an oven, radiator, or other heat
ill fall below 40°F (5°C). Do not
Check the strength of the floor before installing your appliance. It should hold the
cm) of airspace at the top
” between the back of the appliance
a wall, leave extra
space on the hinge side so the door can open wider than its width.
cm) clearance at the top and sides and a ¼” (0.64 cm)
IF YOUR MODEL HAS THE LETTERS “BI”
AND REQUIRE
S
WHERE AT
electrical shock or
or 20- amp fuse
or circuit breaker is required. It is recommended that a separate circuit serving
outlets that cannot be turned off by a
Loading ...
Loading ...
Loading ...