Loading ...
Loading ...
Loading ...
Assembly (continued)
Vac Assembly
1. Slide the dust drum into the front of the
wet/dry Vac unit when filter assembly is
complete. Position the dust drum
wheels into the drum area slots and
glide into place.
NOTE: When reinstalling the dust drum
and filter support assembly, ensure that
the front of the dust drum is flush with the
lid and motor cover assembly. The dust
drum should fit snugly into place. There
are two pins in the Wet/Dry Vac unit that
must fit into the slots in the drum. This
ensures proper alignment. The dust drum
must be installed properly to ensure the
Wet/Dry Vac functions correctly.
2. Pull the two latches on the front of the
dust drum up and over the latch
holders and press down firmly until
they snap in place. If the pins from the
lid and motor cover assembly are not
aligned, the latches will not lock.
Ak WARNING: To avoid ingesting
debris or water in the impeller and
damaging Vac, never operate without
filter support assembly in place.
Insert Hose
Insert the push button end of the hose
assembly into the inlet of the Vac. The
hose should snap into place. To remove
the hose from the Vac, press the release
button in the hose assembly and pull the
hose out of the Vac inlet, as shown.
Loading ...
Loading ...
Loading ...