Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Powercord not plugged in. Plug into a grounded 3 prongoutlet.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. if problem continues, call electrician.
Using an extensioncord. Do not use extension cords.
Timer is not lined up. Turn timer to the right slightly
and pullto start.
Timer knob not pulled out. Set and pull out knob.
Washer at pause in Allowcycle to continue (see
PERMANENT PRESS IICycle "OperationYourWasher").
(approximatelytwo minutes).
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator isloose. This is normal.
Water Level The top of the agitator ismuch This is normal.
Too Low/Not higher than the highest water
Completely level.This creates a perception
Filling ofthe washer not being full
Tub is Tub pulled forwardwhen Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Unit not level. Ensure front feetare instalIedand
nuts are tightened. Levelwasher.
Reset rear legs (see "installation
Instructions").
Lint on Load Improper sorting. Sort lint giversfrom linttakers
and bycolor.
Overloading. Lint can be trapped in load if
overloaded.Wash smaIler Ioads.
Paperor tissue in pockets. Clean out pocketsbefore washing.
Not enough detergent. Use enough detergent to
hold lint inwater.
Detergent not dissolving. UseAutomatic TemperatureControl
Water temperatures lower (ATC).ATC ensures washwater
than 70°F (21°C). temperature will be warmer than
70°F (21°C).
3O
Loading ...
Loading ...
Loading ...