Loading ...
Loading ...
Loading ...
Beforeyoucall forservice...
Problem
Spotsandfilming
onglassesand
flatware
PossibleCauses What ToDo
Extremely hard water
Low inlet water temperature
Ovedoadhlg the dishwasher
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent
• Use Jet-Dry ®rinse agent to rein(we spots and prevent I/e_ fihn btfildup.
• To ren/(we stubborn spots and preexisting fih-n ii'on/glass_are:
I Ren/(we all metal utensils ti'om file (lish_M/er.
2 Do not add detergent.
3 Select file COOK WAREo, cle.
4 Start file dishwasher and _fll()_ to mn tbr 18 to 22 mim/tes. Dish_lsher
will no_ lx_in the main _ash.
5 Open file door and pour 2 cups (500 nil) of\d/ite vinegar into die
bottorn of file (tish_M/er.
6 Close tile door and allo_ to cornplete tile c}cle. If vineK,u"rinse doesn't
_mrk: Repeat as abe\e, except use 1/4 cup (60 nil)of citric acid cr?:stals
instead of _ineg_,u:
An overall yellow or brown Flhn can • A special filter in tile water supply line is tile only war to correct
be caused by iron deposits in water this problern. Contact a _aer softener compan}.
White film on inside Hard water nmlerals • To clean tile interior, apply dish_M/er deteNent to a dan/p sponge.
surfaces _ar robber glo_es. Do not tlse any type of cleanser other than
(lisl/_lsl/er demNent because it may cruse iomning or sudsing. Cascade%
Cascade Complete _ and Electmsol _Automatic Dislm_M/ing Demrgents
have been approved tbr use in all GE dislm_M/ers.
Dishes don't dry Low inlet water temperature • Make sure inlet x_imr mrnperan/l_ is corl_ct (see page 6).
• Select HEATEDDRY.
Rinse agent dispenser is empty • Check tile rinse agent dispenser
Controlpanel responded Door latch may not be properly • Call for sel_'ice.
toinputsbutdishwasher seated
neverfilledwith water
Dishwasherwon'trun Fuse is blown, or the • Replace fuse or reset circuit breaker, gernove any other apt)liames fl'orn
circuit breaker tripped tile circuit.
• %'3 resetting tile START/RESETpad.
Steam This is normal • Steam cornes throug]l the vent by tile door latch during drying and
when water is being pun/ped out.
Sanitized light does The door was opened and the • D11not inmrrupt tile cycle aiwtime during or alter main _lsl/.
not illuminate at the cycle was interrupted during
endof thecycle or after the main wash portion
(Anti-Bacteria The hlcoming water • Raise tile _ater heater ten/perature to 120°E
cycleonly) temperature was too low
/2
Cloudiness on Combhmtion of soft water and • This is c_flled etching and is pem_anent. To pre_ent this ti'orn happening,
glassware too much detergent use less detergent iiyou hme soft wamr Wash glass_tre ill tile shortest
ctrle that will get then/clean.
Water temperature entering • i,ower tile water heater temperature.
the dishwasher exceeds 150°F
Black orgray Alun_unn utensils have • Ren/o_e n/arks with a n/lid, abrasive cleanel:
marksondishes rubbed agah_st dishes
Yellowor brownfilm Tea or coffee stah_s • Ren/o_e the stain by hand, using a soh/fioI_ ot 1/2 cup bleach and
on inside surfaces 3 cups _m'n/_tei-
A
CAUTION: e ¢,recleaning interior _,,aitat least 90 l_,/inlttes
after a cycle for tile heating elen/ent to cool down. Failm_ to (111so
can resl_lt in burns.
Loading ...
Loading ...
Loading ...