Loading ...
Loading ...
Loading ...
Assemble stand (Fig. A)
,
2.
.
4.
.
6.
,
,
g,
Unpack all parts and group by type and size (Fig. A).
Refer to parts list for cuantities.
Attach one long upper support (11, 17) to top of leg (t)
using one square neck bolt (2) and nut (8).
NOTE: Do not tighten bolts until stand is properly aligned
(see step #9).
Attach other end of long upper support to top of another
leg using one square neck bolt and nut.
Attach one long bottom support (3) to center of each leg
using square neck bolts and nuts. This completes the
front frame section.
Assemble rear frame section in exactly the same way.
Join front and rear frame assemblies using two short
upper supports (9) and two short bottom supports (t3),
square neck bolts and nuts.
Insert large hex head bolt (4) into leg spacer (5) and
insert into bottom of leg. Fasten with washer (6) and nut
(7). Repeat for each leg.
Attach the hooks (14) to the frame as desired. The hooks
are used to hold the fence, the blade wrenches and miter
gauge.
Place stand on level surface and adjust so all legs are
contacting the floor and are at similar angles to the floor.
Tighten all bolts.
NOTE: Stand should not rock after all bolts are tightened.
Fig. A
Assemble table saw to stand (Fig. A, B)
1. Place protective corrugated cardboard or old
blanket on floor to protect the saw table surface.
2. Place the saw up-side down on the protective
material (Fig. B).
3. Position the stand up-side down on the saw base.
NOTE: Make sure front of stand (identified with
Craftsman label) and front of saw are facing the
same direction.
4. Position the dust chute between the stand and saw.
5. Line up four holes in saw base, dust chute and
stand.
6. Fasten saw to dust chute and stand using four bolts
(10), washers (11) and nuts (8).
NOTE: Place washer on each bolt before inserting
into saw base and through the support. Nut must
be flush against the bracket (see Fig. A).
7. Tighten all four nuts.
NOTE: DO NOT OVER TIGHTEN NUTS HOLDING
SAW TO STAND. THIS WILL DAMAGE THE SAW
BASE.
8. Carefully set the saw in its upright position on a
clean level surface.
Fig. B
i
/
/
1
Loading ...
Loading ...
Loading ...