Loading ...
Loading ...
Loading ...
Customer Responsibilities
Before Daily
each or after
each
use
use
3heck Safety VaLve
:::)rainTank
O
O
cycles automaticamly when power
is on, When servicing, you may
be exposed to voltage sources,
compressed air, or moving parts,
Before servicing unit unpmug or
disconnect emectricamsuppmy to
the air compressor, bleed tank
of pressure, and allow the air
compressor to cool
NOTE: See "Operation" section for
the location of controls.
To Check Safety Valve
does not work properly, over_
pressurization may occur, causing
air tank rupture or an expBosion.
1. Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be replaced
with the same type of vaive.
To Drain Tank
1_ Set the On/Auto/Off lever to
"OFF".
2. Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
3. Remove the air toot or accessory.
4. PulI ring on safety valve alIowing
air to bIeed from the tank until
tank pressure is approximately
20 psi. Release safety valve ring.
5. Drain water from air tank by
opening drain valve on bottom of
tank.
_ Water will
condense in the
air tank, If not drained, water will
corrode and weaken the air tank
causing a risk of air tank rupture,
6. After the water has been drained,
cIose the drain valve. The air
compressor can now be stored.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, the
reinstalled.
15- ENG A08595
Loading ...
Loading ...
Loading ...