Loading ...
Loading ...
Loading ...
Operating the appliance aus
21
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display `.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button H + until the digital
display ` jumps to œ:‹‚.
4. Press H + or – button until the
displayed time corresponds with your
requirements.
5. Press START button X, timer
programming is activated.
6. To delete timer programming, press
the H + or – button until ` œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
End of programme
The programme has ended when the
value ‹:‹‹ is indicated on the numerical
display `.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button X until
š:‹.... is indicated on the digital
display.
4. Release both buttons.
5. Press programme button # until
the factory set value ›:‹ƒ is
indicated on the digital display `.
To change the setting:
1. Press programme button 3. Each
time the button is pressed, the set
value increases by one level; when
the value of ›:‹„ has been reached,
the display jumps back to ›:‹‹ (off).
2. Press START button X, the set
value is saved.
3. Close the door.
Loading ...
Loading ...
Loading ...