Loading ...
Loading ...
3
REV 0 - 1709011350
L-C2-444
1
1
/2"
hole
(gas)
Fig. 3-3 Install insulating liner
1
1
/2"
electrical hole
(if applicable)
Fig. 3-4 Install grill into liner
Grill hanger
rests on
insulating liner
(sides and rear)
SPECIFICATIONS (cont.)
INSTALLATION
1. Install the insulating liner as shown in Fig. 3-3.
• If installing on a countertop with an irregular/textured
surface, a bead of silicone sealer rated for 400° or higher
may be needed to protect from the elements.
• The insulating liner has knock-out holes (two at the front,
and two at the rear) for electrical feeds (if applicable), and
the gas feed.
Note: If possible, use the front hole for electrical feeds. See
Fig. 3-3.
2. Install your grill per your grill owner's manual.
Important: Do not allow the grill hanger to come in contact
with the countertop or any combustible surface
(
see Fig. 3-4).
Substrate
When adding any substrate to the enclosure front wall (including tiles, stone, etc.), make allowance for:
Substrate Behind Liner Flange
Substrate Alongside Liner Flange
C
C
Flush
(Countertop)
(Countertop)
Liner fl ange
(both sides)
Substrate
(includes tiles,
etc. at front of
enclosure)
Countertop
overhang
(if applicable)
Liner
Liner
Substrate
(includes tiles,
etc. at front of
enclosure)
Any additional substrate alongside the liner fl anges does
not need to be considered in Dim. C (see previous page).
Substrate
+
countertop "front to back" cutout
must equate to Dim. C (see previous page)
when the substrate sits fl ush behind the
liner fl anges.
Fig. 3-1 Fig. 3-2
Countertop
overhang
(if applicable)
TOP VIEW
TOP VIEW
Flush
Liner fl ange
(both sides)
Loading ...