Loading ...
Loading ...
Loading ...
INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed:
• Flat-blade screwdriver • Knife
• Adjustable wrench that • Safety glasses
opens to 1 in. (2.5 cm) or
9/16in.open-end wrench • Duct tape
(for adjusting dryer feet) • Caulking gun and
• Level compound (for installing
new exhaust vent)
• ¼ in. nut driver or socket
wrench • Gloves
• Wood block (for leveling) • Pliers that open to 1 9/18
in. (3.95 cm)
• Tin snips (newvent
installations)
Parts supplied
Remove parts package from the washer basket. Check that all
parts were included.
O_1 _20 3 _ 4
Parts listed are available from your local Sears store or Sears
Service Center. For more information, please reference the
service numbers located on the back page of this manual.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller than available)
96 in. (2.4 m)
1 in. (2.5 cm) 2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe diameter standpipe adapter, Part
Number 3363920
Overhead sewer Standard 20 gal. (76 L) 34 in. (86.4
cm) tall drain tub or utility sink and
sump pump (available from local
plumbing suppliers)
Floor drain Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain Drain protector, Part Number 367031
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 rn) Par[ Number 350008
L }cst ©_'t _,@(;_,, y@'_sx?yl1:,s
1, Water inlet hoses (2)
2. Intet hose flat washers (4)
3. Rear leveling legs (2)
4. Front leveling legs (2)
5. Plastic strap
& Drain hose
7. Yellow, single wire hose clamp
8. Silver, double-wire hose clamp
Parts needed
Check local codes, electrical supply and venting, and read
"Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require
• Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. See
"Venting Requirements."
• A 120-volt, 60-Hz., AC-only, 15- or 20-amp circuit.
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the laundry center. See "Electrical
Requirements."
• A sturdy floor to support the laundry center weight (laundry
center, water and load) of 500 Ibs (226.8 kg).
Loading ...
Loading ...
Loading ...