Loading ...
Loading ...
Loading ...
19
TROUBLESHOOTING
WARNING
Disconnect the spark plug wire and ground it against the engine to prevent
unintended starting. Before performing any type of maintenance/service,
disengage all controls and stop the engine. Wait until all moving parts
have come to a complete stop. Always wear safety glasses during operation
or while performing any adjustments or repairs.
This section addresses minor service issues. To locate the nearest Sears Service Center or to schedule service, call the following toll free number: 1-888-
331-4569.
Problem Cause Remedy
Engine Fails to start
1. Blade control disengaged.
2. Fuel valve is OFF (if equipped with fuel valve).
3. Spark plug boot disconnected.
4. Fuel tank empty or stale fuel.
5. Engine not primed (If equipped with primer).
6. Faulty spark plug.
7. Engine flooded.
8. Blocked fuel line.
1. Engage blade control.
2. Move the fuel valve lever to ON.
3. Connect wire to spark boot.
4. Fill tank with clean, fresh gasoline.
5. Prime engine as instructed in the Operation section.
6. Clean, adjust gap, or replace.
7. Wait a few minutes to restart.
8. Contact your Sears Parts & Repair Center to have fuel line
cleaned.
Engine runs erratic 1. Spark plug boot loose.
2. Stale fuel.
3. Vent in gas cap plugged.
4. Water or dirt in fuel system.
5. Dirty air cleaner.
6. Blocked fuel line.
1. Connect and tighten spark plug boot.
2. Fill tank with clean, fresh gasoline.
3. Clear vent.
4. Run engine until it stops from lack of fuel. Refill with fresh fuel.
5. Refer to Air Cleaner Maintenance in Engine Manual.
6. Contact your Sears Parts & Repair Center to have fuel line
cleaned.
Engine overheats 1. Engine oil level low.
2. Air flow restricted.
1. Fill crankcase with proper oil.
2. Clean area around and on top of engine.
Occasional skips (hesitates) 1. Spark plug gap too close. 1. Adjust gap. Refer to Spark Plug Maintenance in Engine Manual.
Idles poorly 1. Spark plug fouled, faulty, or gap too wide.
2. Dirty air cleaner.
1. Reset gap or replace spark plug.
2. Refer to Air Cleaner Maintenance in Engine Manual.
Excessive vibration 1. Cutting blade loose or unbalanced.
2. Bent cutting blade.
1. Tighten blade and adapter. Balance blade.
2. Replace blade.
Loading ...