Loading ...
Loading ...
Loading ...
• If tube end is damaged, cut off _'o"before
recollnectlng.
If leaking occurs, reconnect the line.
3. Close doors.
/4. Remove top hinge covers by
removing Philhps screws.
5. Unscrew %," hex head screws from
top hinges.
For water dispensing
models only:
• Do not renlove screw
connecting green ground
W l re.
6. For ice and water dispensing models only:
Detach main wire connector harness and red wire
harness.
To detach mare wire
harness, use a flat blade
tool or fingernail to press
jLinCtlOn point between two
connectors to release.
• To detach red wire harness, press
tab on underside of connector to
release.
7. Remove top hinges along with doors.
8. Remove bottom hinges with a ',:' hex head dnver.
Replacing the Doors
• To replace the doors, follow the steps m Door and
Hinge Removal m reverse order.
IMPORTANT: If water hne tube end is damaged, cut
off _o" before reconnecting.
Connecting the Water Supply
(:select models)
To reduce the risk of injury or death, follow
basic precautions, including the following:
• Read all instructions before mstalhng ice maker.
• Do not attempt installation ff instructions are not
Lmderstood or if they are beyond personal skill
level.
. Obsen/e all local codes and ordinances.
• Do not sen/ice ice maker unless specifically
recommended m Use & Care Guide or pubhshed
user-repair instructions.
. Disconnect power to refngerator before mstalhng
ice makeL
• Water damage due to an improper water
connection may cause mold/mildew growth. Clean
up spdls or leakage H_med_ately!
To avoid property damage or possible injury,
follow basic precautions, including the
following:
. Consult a plumber to connect ¼" O.D. copper
tubing to housellold pJumbmg to assure
comphance with local codes and ordinances.
• Verify the copper tubing under the sleeve is smooth
and free from defects. Do not reuse an old sleeve.
• Confirm water pressure to water valve B between
35 and 100 pounds per square inch, 20 pounds
per square inch without filter.
. Do not use a self-piercing, or f.',J'saddle valve. Both
reduce water flow and can become clogged over
time, and may cause leaks if repair is attempted.
o Taghten nuts by hand to prevent cross threading.
FmBh tlghtemng nuts with phers and wrenches.
Do not overhghten.
• Wamttwo to three hours before placing refrigerator
into final position to check and correct any water
leaks. Recheck for leaks after 24 hours.
• Verify the copper tubing under the sleeve is
smooth and free from defects. Do not reuse an
old sleeve.
Loading ...
Loading ...
Loading ...