Loading ...
Loading ...
Loading ...
Surface Elements and Drip Bowls
Surface elements can be unplugged and removed to make cleaning the drip pans easier. The surface elements clean
themselves when they are turned on. Food spilled on a hot element will burn off. Food spilled on a cool element may be
cleaned with a damp cloth--any remaining soil will burn offthe next time the element is used.
Hold
Down
Never immerse a surface element in water.
To Remove the Surface Elements and Drip Bowls
Allow Element
on drip pan
inside rim.
<
Terminal End
Ferminal
Plug
Be sure the range is cool
before removing elements or drip bowls. Be
careful not to bend terminal ends when
replacing elements after cleaning.
Main top
Lift-up
[!r_!l_"_! When lowering the lift-up
range top, grasp the sides with finger-tips
only. Be careful not to pinch fingers. DO
NOT drop or bend the range top when
raising or lowering. This could damage
the surface.
1. Lift the edge of the drip bowl across from the terminal end. Lift the surface
element and drip bowl together just enough to clear the cooktop.
2. While holding the drip bowl and surface element, gently pull the terminal end
out from the terminal plug. Ifequipped, DO NOT remove the holddown clip from
the drip bowl.
To Clean Drip Bowls
Wash in hot, soapywater or in the dishwasher. Rinse and drywhile still warm. Hard
to remove, burned on soil can be removed by soaking the drip bowls for about 20
minutes in a lightly diluted liquid cleanser or a solution of ammonia and water (1/
2 cup ammonia to 1 gallon ofwater). A nylon scrubber may be used after soaking.
DO NOT use abrasive cleaners or steel wool, as they will scratch the surface.
Always rinse with clean water and polish dry with a soft cloth.
To Replace Drip Bowls and Surface Elements
1. Slide the terminal end on the element through the opening in the drip bowl.
2. Align the element support torest on the rim inside the drip bowl. Ifyour drip bowl
is equipped with a hold down clip, align the element support opposite the
terminal end with the slot in the hold down clip, and snap into place.
3. After the element is positioned in the drip bowl, line up the terminal end with
the terminal plug as shown.
4. Hold the surface element and drip bowl togetheras level as possible and firmly
push the terminal end into the terminal plug. Make sure element terminal is
seated properly into terminal plug. Make sure the surface element is level to
reduce the hazard of pans sliding off the element.
To Raise the Top for Cleaning
1. Grasp the sides and lift from thefront. Lift-up rods will support the top in a raised
position. Only lift the top far enough to allow the support rods tosnap into place.
2. Clean underneath using a clean cloth and hot, soapy water.
3. To Iowerthe top, gently push backon each rod to release the notched support.
Hold the range top and slide the lift rods down into the range frame.
16
Loading ...
Loading ...
Loading ...