Loading ...
Loading ...
Loading ...
Page 18 of 28 802005 - Sparkling HT-BCS Residential- Installation Instructions - 09.2016 - v3.01
IMPORTANT:
After replacing a bottle or after making a
gas connection, check for gas leaks:
Stage1:
1.
Turn the gas OFF
2.
Using soapy water applied with a sponge, or with
a brush, cover all of the gas joints with a liberal
amount of suds.
Stage 2:
1.
Turn ON the gas
2.
Inspect the joint for leaks
3.
If any bubbles appear, the joint
will need to be resealed.
CO
2
Connections & Leak Testing
4.4
Test for gas leaks:
Using soapy water perform a leak test. Apply the soapy water to the gas connections using a sponge. If any
bubbles appear and grow, there is a gas leak at the connection. Clean away the soapy residue and tighten
or refit the leaking connection. Make sure the regulator is turned off when tightening or refitting the leaking
connection.
Refit the gas bottle to the Hook-and-loop strap and secure the bottle in an upright position.
NOTE:
Care must be taken when working with high pressure carbon dioxide, and in no cases should the
normal operating pressure of 2.7-3.0 bar (270-300kPa) be exceeded.
Connect the unit to the mains power supply.
Loading ...
Loading ...
Loading ...