Loading ...
Loading ...
Loading ...
18
Essential information
n
Before thorough cleaning, turn o the circuit
breaker. Allow the range to cool.
n
After cleaning remember to switch on the circuit
breaker before using the range.
n
NEVER use paint solvents, caustic cleaners,
biological powders, bleach, chlorine based bleach
cleaners, coarse abrasives or salt.
n
DO NOT mix dierent cleaning products – they may
react together with hazardous results.
Recommended cleaning materials are shown in Table 6.1 on
page 21.
Cooktop
Daily care
First of all make sure that all heat indicator lights are o and
that the cooking surface is cool. Apply a small dab of AGA
Ceramic Hob Cleaner (SAG-W2022) in the centre of each area
to be cleaned. Dampen a clean paper towel and work the
cream onto the cooking surface. As a nal step, wipe the
cooking surface with a clean, dry paper towel.
AGA Enamel Rubber Eraser
(SAG-W1843) removes scu marks
on ceramic, without scratching, providing easy cleaning for
daily use.
Cleaning spills
For spills and boil-overs that occur while cooking, turn the
unit o and wipe the area surrounding the hot zone with a
clean paper towel. If a spill (other than a sugary substance) is
on the hot zone, do not clean until the unit has completely
cooled down, and then follow the instructions below
(‘Cleaning Burned-on Spills’).
If you accidentally melt anything on the surface, or if you spill
foods with a high sugar content (preserves, tomato sauce,
fruit juice, etc.), remove the spill IMMEDIATELY with a razor
scraper, while the unit is still hot.
n
IMPORTANT: Use an oven glove to protect your hand
from potential burns.
Scrape the major spill or melted material from the cooking
zone and push into a cold area. Then, turn the unit ‘OFF’ and
allow it to cool before cleaning further. After the cooking
surface cools down and the heat indicator lights go o, follow
the ‘Daily Care’ procedure outlined above.
Cleaning burned-on spills
Make sure that the heat indicator lights are o and that the
cooktop is cool. Remove the excess burned-on substance
with a single-edged razor scraper. Hold the scraper at an
angle of about 30° to the surface and then scrape o the
burned-on matter.
6. Cleaning your range
Loading ...
Loading ...
Loading ...