Kenmore 66561701100 Microwave Hood Combination

Use & Care Guide - Page 7

For 66561701100. Also, The document are for others Kenmore models: 665.61701*, 665.61709*

PDF File Manual, 75 pages, Read Online | Download pdf file

66561701100 photo
Loading ...
Loading ...
Loading ...
Installation Instructions
REMOVING AND REPLACING THE MICROWAVE HOOD
COMBINATION
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other
injury.
If you need to remove your Microwave Hood
Combination for any reason, follow these simple
steps:
To remove:
1. Unplug microwave oven
2. Remove filters and vent
or disconnect power.
rille.
If filters Q are
installed, push in at
the tab and slide filter
to the outside edge to
remove.
Remove the two
screws _) from the
top of the microwave
oven cabinet (the
screws located
closest to the front
corners). Do not
remove the screws
located towards the center of the cabinet.
Remove the vent grille (_. Set the screws and
grille aside.
3. After removing all oven contents, including the
turntable and
support, tape the
door in the closed
position. Then
remove the two
screws _) securing
the microwave oven
to the upper cabinet.
4. While wearing gloves, grasp the microwave oven
supports _ and firmly
pull the microwave oven
| (_ forward and downward to
I LL---J LA, J II release the microwave
_=====_\-q,L_ oven cabinet from the
pms
mounting plate locking
5. Grasp the microwave oven cabinet. Rotate the
microwave oven
downward. (Be careful
that door does not
swing open.) Lift off
the support tabs (_
at the bottom of the
mounting plate. Set
the microwave oven
aside on a protected
surface.
To replace:
1. Carefully lift microwave oven and hang it on the
support tabs at the bottom of the mounting plate.
2. Rotate the front of the microwave oven cabinet
downward. Thread the power supply cord
through the power supply cord hole in the
bottom of the upper cabinet.
3. Rotate the microwave oven towards the cabinet.
Push the microwave oven against the mounting
plate until locking pins snap into the cabinet.
4. Replace the two screws securing the microwave
oven to the upper cabinet.
5. Untape the door and replace the turntable and
support.
6. Replace the vent grille.
7. Replace the two screws in the top of microwave
oven cabinet (the screws located closest to
front corners).
8. If filters were installed, replace them (see "Install-
ing and caring for the filters" in the "Caring for
Your Microwave Oven" section, if needed).
9. Plug in microwave oven or reconnect power.
Loading ...
Loading ...
Loading ...