Loading ...
Loading ...
Loading ...
Ceramic Cooktops TROUBLESHOOTING 9
troubleshooting
PROBLEM POSSIBLE CAUSE REMEDY
You cannot activate the appliance or
operate it.
The appliance is not connected to
an electrical supply or it is connected
incorrectly.
Check if the appliance is correctly
connected to the electrical supply (refer to
connection diagram).
Activate the appliance again and set the
heat setting in less than 10 seconds.
You touched 2 or more sensor fields at the
same time.
Touch only one sensor field.
There is water or fat stains on the control
panel.
Clean the control panel.
The appliance deactivates.
You put something on the sensor field
.
Remove the object from the sensor field.
The residual heat indicator does not come
on.
The cooking zone is not hot because it
operated only for a short time.
If the cooking zone operated sufficiently
long to be hot, speak to the service
centre.
The sensor fields become hot.
The cookware is too large or you put it
too near to the controls.
Put large cookware on the rear cooking
zones if necessary.
comes on. The Automatic Switch Off operates.
Deactivate the appliance and activate it
again.
and a number come on. There is an error in the appliance.
Disconnect the appliance from the
electrical supply for some time. Disconnect
the fuse from the electrical system of the
house. Connect it again. If
comes on
again, speak to the service centre.
If you tried the above solutions and cannot re- pair the problem,
speak to your dealer or the customer service. Give the data from
the rating plate, and an error message that comes on.
Make sure, you operated the appliance correctly. If not the
servicing by a customer service technician or dealer will not be
free of charge, also during the warranty period. The instructions
about the customer service and conditions of guarantee are in
the guarantee booklet.
Loading ...
Loading ...
Loading ...