Loading ...
Loading ...
Loading ...
page 7
8. Blade Assembly.
blade arm screws
lock washers
motor housing
blade arm
plastic
motor lock
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 12 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock washers
to secure blade arms). Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
blade attachment
screws and washers
blade
9. Light Kit Assembly. (Optional)
If you wish to use your fan WITHOUT the light kit,
please proceed to Section 10 on page 8 to complete
installation WITHOUT the light kit.
If you wish to use fan WITH the light kit, remove
3 screws from switch housing and remove switch
housing cap.
Locate BLUE (or BLACK) and WHITE wires in switch
housing labeled FOR LIGHT. Remove and discard
plastic that holds these two wires together.
switch
housing
switch housing cap
white wire
blue (or
black) wire
motor
housing
Punch center cap out of switch housing cap with a
screwdriver. Remove the hex nut and lock washer
from threaded rod at top of light kit fitter. Feed wires
from light kit fitter through center hole in switch
housing cap. Then, screw switch housing cap onto
threaded rod on light kit fitter followed by lock
washer and hex nut. Tighten hex nut over lock
washer for a secure fit.
["Light Kit Assembly" continued on next page.]
hex nut
lock washer
light kit
fitter
switch housing
cap
hex nut
lock washer
center
cap
Loading ...
Loading ...
Loading ...