Loading ...
Loading ...
Loading ...
4
INSTALLATION
CAUTION: After unpacking you MUST allow this appliance to stand upright
for at least 2 hours to allow the lubricant and refrigerant to drain back into
the compressor and stabilize. Failure to do so may adversely affect
performance and the lifetime of this unit.
Before Using This Appliance
• Remove all exterior and interior packing.
• Check to be sure shelves are installed and that the strips of tape
holding them in place have been removed.
• Level the appliance with the adjustable legs provided.
• All controls should be in the OFF position.
• Clean the interior surfaces with lukewarm water using a soft cloth. Any
plastic odor that you notice when you first open the doors will dissipate
once the appliance is operating.
• This appliance is designed to be free-standing only, and should not be
recessed or built-in.
Installing Your Appliance
• Install the anti-tip bracket included with the unit by following the
enclosed instructions.
• Place your appliance on a floor that is strong enough to support it when
it is fully loaded. Be sure the appliance is level. (Level the unit cabinet
by adjusting the legs at the front.)
• For proper air circulation, leave at least 2 inches of space between the
back of the unit and the wall behind, and 4 inches at the sides and top.
• Plug the unit into a 120V AC 60Hz electrical source. The fuse or circuit
breaker should be rated for 15 amperes.
• The unit is designed to be used in a stable environment where the ideal
ambient temperature is 72°F or less. Extremely warm or cold ambient
temperatures may cause the appliance to perform improperly.
• Avoid locating the unit in moist areas.
Loading ...
Loading ...
Loading ...