Loading ...
Loading ...
Loading ...
OCCURRENCE POSSIBLECAUSE SOLUTION
WASHER- OPERATING
(continued)
Washer does not start Cycle selector is not in correct position. Move indicator clockwise slightly. Pull out knob.
(continued),
Motor is overheated. Washer motor will stop if it becomes overheated. It wi
automatically restart after a cool down period of up t_
30 minutes (if washer has not been manually turnec
off).
Washer won't spin. Lid is not completely closed. Close lid completely. Safety lid lock must not b
broken.
Residue left in tub. Heavily soiled items. Wipe tub with a nonabrasive household cleanser, thel
rinse. Shake or brush excess dirt and sand from item
before washing.
WASHER- WATER
Wash load too wet after Washer is overloaded Do not overload washer See Washing Procedures
spin.
Load is out of balance Rearrange load to allow proper spinning
Drain hose is kinked Straighten drain hose
Water does not enter Water supply is not adequate in area. Check another faucet in the house. Wait until wate
washer or it enters slowly, supply and pressure increase.
Water supply faucets are not completely
open. Fully open hot and cold faucets.
Water is being used elsewhere in the house. Water pressure must be at least 30 psi (260 kPa:
Avoid running water elsewhere while washer is fillinc
Water inlet hoses are kinked. Straighten hoses.
Water level does not cover Improper water level selection (for Select higher water level/load size.
load, models with water level/load size control).
Washer is overloaded. Do not overload washer. When control is set at highes
fill level, dry load level should not be higher than to I
row of circular holes in wash tub.
Warm or hot water is not Hot water heater is set too low or is a Measure hot water temperature at nearby faucet witl
hot enough, distance from laundry center candy or meat thermometer Water temperatur
should be at least 130°F (70°C) Adjust water heate
as necessary
Hot water is being used elsewhere in
the house.
Avoid using hot water elsewhere before or durinc
washer use There may not be enough hot wate
available for proper cleaning If problem persists, you
hot water system may be unable to support more thai
1 use at a time.
Water in washer does not Drain hose is kinked or clogged Clean and straighten the drain hose
drain or drains slowly.
Water leaks. Fill hose connection at faucet or washer Check and tighten hose connections Install rubbe
sealing washers provided
House drain pipes are clogged Unclog drain pipes Contact plumber if necessary
Oversudsing Use less detergent
Incorrect wash and rinse Hot and cold water hoses are connected Connect hot water hose to hot water faucet and coh
temperatures, to wrong supply faucets water hose to cold water faucet
Water is entering washer Drain hose standpipe is incorrect height Standpipe must be a minimum of 33" (83.82 cm) higl
but tub does not fill. to prevent siphoning See INSTALLATIO[
INSTRUCTIONS
14
Loading ...