INSTALLATION:
PENDANT LIGHT
4. Once wire connections are
completed, carefully tuck wires
and wire nuts into the electrical
box making sure no bare wire (on
the black and white) is visible at
the wire nuts. Install the light
fixture to the ceiling by aligning
the hole(s) in the fixture with the
studs on the mounting bracket.
Secure fixture in place with star
washers and cap nuts.
5. Install specified bulb type
and wattage (not included).
Tel: (613) 342-5424, Fax: (800) 263-4598
Black
Electrical
Box
Star
Washer
Cap Nut
Fixture
Stud
Wood screw
Back
Cover
House supply
Ground wire
Fixture
Ground wire
Electrical
Box Screws
(not included)
1. Position the back cover
on the ceiling with the center
hole over the electrical box.
Mark the ceiling for the pilot
hole locations through the
small holes on either end. Drill
pilot holes at each location.
Position the back cover and
add wood screws (one on each
side) for the wooden studs or
plastic wall anchor and wood
screws for dry wall.
2. Feed power cords from
the electrical box through the
center hole of the back cover.
Align holes of back cover over
electrical box and secure with
electrical box screws (not
included).
NOTE: Make sure the back
cover is level before tightening
the screws.
3. Connect the ground wires
(bare copper or green) from
your fixture to the ground wire
(bare copper or green) or
ground screw in the electrical
box. Connect the black wire
from the fixture to the black
wire in the electrical box and
connect the white wire from
the fixture to the white wire in
the electrical box.
White
IPL764A03XX10
09/18
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
!
WARNING
Warning - HOT :
Do not touch any metal surface.
Bulb
Loading ...
