Loading ...
Loading ...
Loading ...
DIRT SENSOR
The dir
When the vacuum cleaner is in use, with the
switch in the CARPET position, the blue light
on the top of the brush will illuminate to show
that dirt is being vacuumed. As long as the
light is on, dirt is passing across the sensor to
indicate that the surface still needs cleaning.
When the sensor light turns o, the sensor is
not seeing enough dirt to warrant further
cleaning of that area.
TO CLEAN DIRT SENSOR LENSES
The dirt sensor lenses are located on the
be cleaned periodically.
1. Remorom nozzle.
2. Town.
3. The two dirt sensor lenses are located on
the inside of the opening as shown. Brush
each sensor lens several times to remove dust
and dirt.
PERFORMANCE/SAFETY FEATURES
WARNING
Personal Injury Hazard
"
cleaner before cleaning the agitator area
as agitator may suddenly restart. Failure
to do so can result in personal injury.
OVERLOAD PROTECTOR
The PowerMate
®
has built-in protection
against motor and belt damage should the
agitator jam. If the agitator slows down or
stops, the overload pr
PowerMate
®
. The canister motor will continue
to run.
To correct problem: T
vacuum cleaner, remove obstruction, then
press OVERLOAD PROTECTOR RESET
button.
If the
PowerMate
®
motor still does not run
after reset, have the unit serviced by a Sears
or other
RESET
OVERLOAD
PROTECTOR
ELECTRONIC SUCTION CONTROL
The electronic suction control allows you to
change the power of the vacuum cleaner
suction motor.
Increase suction
for upholsteries
and carpets.
Decrease suction
for draperies and
lightweight rugs.
Increase
Suction
SUCTION
CONTROL
Decrease
Suction
Dirt
Sensor
Dirt Sensor
Lenses
CAUTION
Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make cleaning
necessary sooner.
- 16 -
Loading ...
Loading ...
Loading ...