Loading ...
Loading ...
Loading ...
10 49-1000502 Rev. 0
ROLLERS AND LEVELING LEGS
Leveling legs near each front corner of the refrigerator
are adjustable. They firmly position the refrigerator
and prevent it from moving when the doors are
opened. Leveling legs should be set so the front of
the refrigerator is raised just enough that the doors
close easily when opened about halfway.
Turn the leveling legs clockwise to raise the
refrigerator, counterclockwise to lower it.
Rollers next to the leveling legs allow you to move the
refrigerator away from the wall for cleaning.
Turn the legs counterclockwise until the weight of the
refrigerator is transferred from them to the rollers.
After rolling the refrigerator back into place, turn the
legs clockwise until the legs again bear the weight of
the refrigerator.
Installation Instructions For All XRS and XRE Models
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
•Sides3/4”(19mm)on16&18cuftmodels
•Sides1/8”(3mm)on22cuftmodels
•Top1”(25mm)
•Back1”(25mm)on16cuftmodels
• Back 2" (50 mm) on 18 & 22 cuft models
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for
local inspector’s use.
• IMPORTANT – Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keeptheseinstructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
Reversing the Door Swing
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 55°F (12.7°C) because it will not run
often enough to maintain proper temperatures.
Models with adjustable control in the freezer
compartment can be installed at temperatures at,
but not below, 38°F (3.3°C).
• Do not install the refrigerator where the
temperature will go above 110°F (43.3°C)
because it will not perform properly.
• Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
WATER SUPPLY TO THE ICE
MAKER (on some models)
If the refrigerator has an ice maker, it will have to
be connected to a cold water line. A water supply
kit (containing copper tubing, shutoff valve, fittings
and instructions) is available at extra cost from your
dealer, by visiting GEAppliances.com, or from Parts
and Accessories, 1.877.959.8688. See instructions
Installing the Water Line.
If you have questions, call Crosley at 800.544.4780 or visit our Website at: Crosley.com.
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...