Loading ...
Loading ...
Loading ...
28 49-1000329 Rev. 3
Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
Ŷ Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Ŷ Do not install the refrigerator where the
temperature will go above 100°F (37°C) because
it will not perform properly.
Ŷ Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
Ŷ Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
6LGHV ´PP
7RS ´PP&DELQHW+LQJH&RYHU
%DFN ´PP
REMOVING THE REFRIGERATOR
DOORS
Ŷ IMPORTANT NOTE:7KLVUHIULJHUDWRULV´
(943 mm) deep (refer to chart on previous page).
Doors and passageways leading to the installation
ORFDWLRQPXVWEHDWOHDVW´PPZLGH
in order to leave the doors and handles attached
to the refrigerator while transporting it into the
installation location. If passageways are less
WKDQ´PPWKHUHIULJHUDWRUGRRUVDQG
handles can easily be scratched and damaged.
The top cap and doors can be removed to allow
the refrigerator to be safely moved indoors. If
SDVVDJHZD\VDUHOHVVWKDQ´PP
start with Step 1.
Ŷ If it is not necessary to remove doors, skip to Step
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
Ŷ NOTE:8VHDSDGGHGKDQGWUXFNWRPRYHWKLV
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
1
REMOVE THE REFRIGERATOR
AND FREEZER DOOR HANDLES
(if necessary)
Handle design varies; however installation is the
same.
1. Tighten/loosen the handle to/from the door by
WXUQLQJVHWVFUHZZLWK´$OOHQZUHQFK/HDYH
film on door until installation is finished.
2. If handle mounting fasteners need to be
WLJKWHQHGRUUHPRYHGXVHD´$OOHQZUHQFK
Mounting
Fasteners
Mounting
Fasteners
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...