Loading ...
Loading ...
Loading ...
ENGLISH
The Autoselect feature allow you to set the optimum speed of
the tool dependant on the material you are cutting.
Slide the Autoselect switch (3) to the top position for cut-
ting sheet metal.
Slide the Autoselect switch (3) to the middle position for
cutting plastic.
Slide the Autoselect switch (3) to the bottom position for
cutting wood and metal tubing.
If possible, always hold the tool with both hands using the
main handle (7) and secondary handle (8).
Let the blade run freely for a few seconds before starting
the cut.
Apply only a gentle pressure to the tool while performing
the cut.
If possible, always hold the tool with both hands using the
main handle (7) and secondary handle (8).
Rotate the branch steady (5) till it clicks into place.
Let the blade run freely for a few seconds before starting
the cut.
Position the saw so that the blade is above the branch and
the branch steady (6) is below the branch.
Apply only a gentle pressure to the tool while performing
the cut.
For proper cutting, the branch being cut should be in con-
tact with both sides of the pruning shoe. The cut should
be square to the branch, and not made at an angle. If
required a rotating action could be used to further improve
the speed of the pruning cut.
The branch steady (6) is not a handle and should
never be used as a handle. Always hold the tool using the
main handle (7) and the secondary handle (8 or 9).
If possible, always hold the tool with both hands using the
main handle (7) and secondary handle (9).
Rotate the branch steady (5) till it clicks into place.
Fit the required blade.
Do not exert too much pressure on the tool.
Regularly check the condition of accessories. Replace
when necessary.
Clamp the workpiece securely and remove all nails and
metal objects.
When splintering is to be minimised, e.g. when cutting
laminates, clamp a piece of scrap wood or hardboard to
both sides of the workpiece and saw through this sand-
wich.
Be aware that sawing metal takes much more time than
sawing wood.
Use a saw blade suitable for sawing metal.
When cutting thin sheet metal, clamp a piece of scrap
wood to the back surface of the workpiece and cut through
this sandwich.
Cut downward and away from your body.
Make the cut close to the main branch or tree body.
Your Black & Decker corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
switch off.
Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Loading ...
Loading ...