Loading ...
Loading ...
Loading ...
39
USA
Installation instructions
Before installation
Check that the input voltage indicated on
the characteristics plate is the same as the
voltage of the power outlet you are going to
use. The rating plate is located on the front
part of the cavity and it is only visible after
opening the door.
Open the oven door and take out all the
accessories and remove the packing
material.
Do not remove the mica cover on the ceiling
of the interior! This cover stops fat and pieces
of food damaging the microwave generator.
Warning! The front surface of the oven may
be wrapped with a protective film. Before
using the oven for the first time, carefully
remove this film, starting on the inside.
Make sure that the oven is not damaged in
any way. Check that the oven door closes
correctly and that the interior of the door and
the front of the oven opening are not
damaged. If you find any damage contact the
Technical Assistance Service.
DO NOT USE THE OVEN if the power cable
or the plug is damaged, if the oven does not
function correctly or if it has been damaged or
dropped. Contact the Technical Assistance
Service.
Put the oven on a flat and stable surface. The
oven must not be put close to any sources of
heat, radios or televisions.
During installation, make sure that the
power cable does not come into contact
with any moisture or objects with sharp
edges behind the oven. High temperatures
can damage the cable.
Warning: after the oven is installed you
must make sure you can access the plug.
Electrical Connection
The oven is equipped with a power cable and
a NEMA 6-20P plug for single phase current.
If the oven is to be installed on a
permanent basis it should be installed by a
qualified technician. In such a case, the oven
should be connected to a circuit with an all-
pole circuit breaker with a minimum
separation of 3 mm between contacts.
WARNING: THE OVEN MUST BE
EARTHED.
The manufacturer and retailers do not
accept responsibility for any damage that
may be caused to people, animals or property
if these installation instructions are not
observed.
After installation
The oven only functions when the door is
closed correctly.
After the first use, clean the inside of the oven
and the accessories, following the cleaning
instructions given in the section “Oven
cleaning and maintenance”.
Fit the Turntable support in the center of the
oven cavity and put the Turntable ring and the
Turntable plate on top, making sure they slot
in. Whenever you use the microwave, the
turntable plate and the respective accessories
must be inside and correctly fitted. The
turntable plate can rotate in both directions.
During installation, follow the instructions supplied separately.
Loading ...
Loading ...
Loading ...