Loading ...
Loading ...
Loading ...
STEP 6a - ASSEMBLE HUTCH BRACKETS
, if the tractor hitch is less than 10" above the ground,
place the bent hitch bracket underneath the hitch
tubes and place the hitch bracket assembly on top of
the hitch tubes. Insert two hex bolts (B) through the
brackets, with the rear hex bolt between the cross
bolts in the hitch tubes. Secure the hex bolts (B) with
two nylock nuts (F)= See figure 3=Do not tighten yet.
. Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (L)=See figure 3=
REX BOLTS (B)
"A' C2 t CKET
SPACERS(J) ----_i _
BENT RITCH-- _
BRACKET
FIGURE 3
NYLOCK NUTS (F)
""""" HAmRPmNCOTTER (L)
STEP 6b - ASSEMBLE HUTCH BRACKETS
. if the tractor hitch is 10" or more above the ground,
place the bent hitch bracket on top of the hitch tubes
and place the hitch bracket assembly underneath
the hitch tubes, insert two hex bolts (B) through the
brackets, with the rear hex bolt between the cross
bolts in the hitch tubes. Secure the hex bolts (B) with
two nylock nuts (F)= See figure 4=Do not tighten yet.
. Assemble the two spacers (J) onto the hitch pin and
secure the pin with the hairpin cotter (L)=See figure 4=
FIGURE 4
i
i
NYLOCK NUTS (F)
STEP 7 - TIGHTEN BOLTS
. Tighten the four bolts in figure 1 that fasten the hitch
tubes to the sweeper housing. Next, tighten the two
bolts in figure 2 that fasten the ends of the hitch tubes
together. Finally, tighten the two bolts in figure 3 or 4
that fasten the hitch brackets to the hitch tubes.
STEP 8 - ATTACH HANDLE
, Assemble the height adjustment handle to the height
adjustment tube on the front of the sweeper housing,
Use the curved head bolts, bowed washers, lock
washers and hex nuts which come pre-assembled to
the tube, Position the height adjustment handle side to
side so that the height adjustment strap will align up
against the outside of the handle and then tighten the
nuts. See figure 5=
. Assemble the grip (T) onto the end of the height
adjustment handle as shown in figure 5.
HEIGHT
ADJUSTMENT
HANDLE
CURVED
HEAD BOLT
FIGURE 5
STEP 9 - ATTACH KNOB
, Place the tooth-lock washer (I) between the height
adjustment handle and the height adjustment strap,
Insert the carriage bolt (D) through the handle, the
tooth-lock washer and the strap, Assemble the flat
washer (H) and the plastic knob (U) onto the end of
the bolt and tighten, See figure 6=
HEmGHT
ADJUSTMENT
HANDLE (O)
KNOB (U)
FLAT WASHER (H)
FIGURE 6
Loading ...
Loading ...
Loading ...