Craftsman 316740970 4-Cycle Electric Start Capable Gas Trimmer

Operator’s Manual - Page 14

For 316740970. Also, The document are for others Craftsman models: 316.74093*, 316.74097*

PDF File Manual, 48 pages, Read Online | Download pdf file

316740970 photo
Loading ...
Loading ...
Loading ...
14
STARTING AND STOPPING
WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
position when pulling the starter rope (Fig. 19).
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the Off (O) position until the
engine comes to a complete stop (Fig. 17).
STARTING INSTRUCTIONS
1. Check the oil level. Refer to Checking the Oil Level.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the On ( I ) position at all times (Fig. 17).
3
. Slowly press and release the primer bulb 10 times (Fig. 18).
4. Crouch in the starting position (Fig. 19).
NOTE: PRESS and HOLD the throttle lockout, then SQUEEZE and
HOLD the throttle control for ALL further steps.
NOTE: To prevent the throttle control from being squeezed
accidentally, this unit has a throttle lockout. The throttle control
cannot be squeezed unless the throttle lockou
t is also engaged.
5
. Press and hold the throttle lockout. Squeeze and hold the
throttle control (Fig. 17). Pull the starter rope with a controlled
and steady motion 5 times to start the engine (Fig. 19).
NOTE: This unit uses the INCREDI-PULL™ starting system, which
significantly reduces the effort required to start the engine.
6. Install the shoulder strap (optional). Refer to Installing the
Shoulder Strap.
IF... the engine does not start, begin the starting procedure with step 3.
IF... the engine fails to start after 3 attempts: Press and hold the throttle
lockout. Squeeze and hold the throttle control. Pull the starter rope
with a controlled and steady motion until the unit starts.
IF... the engine stops while the throttle control is squeezed, begin
the starting procedure with step 3.
IF THE ENGINE IS HOT.
.. b
egin the starting procedure with step 3.
Fig. 17
Throttle Control
Throttle
Lockout
On/Off Switch
(I = On / O = Off)
Fig. 19
Starting
Position
Throttle Control
Starter Rope Grip
Fig. 18
Primer Bulb
Loading ...
Loading ...
Loading ...