Loading ...
Loading ...
Loading ...
9
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
ON
T
urn P
o
w
er
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
To install the shade, rst loosen
the thumb screws. Raise the
shade to the light xture. Tighten
all thumbscrews securely.
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs and click “How do I install my
fan without the light kit?”
Hunter Pro Tip:
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Partially install two of the light kit screws
found in the
hardware bag. Align the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Install the last light kit screw.
Tighten all three screws securely.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
2 of 6
3 of 6
6 of 6
4 of 6
Light Kit Screw
Light Kit Screw
Light Kit Screw
Light Kit Screw
BAG
BAG
BAG
BAG
1
STEP
4
STEP
5
STEP
6
STEP
2
STEP
3
STEP
Assembling the Light
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Repeat x3
Repeat x3
Fan style may vary.
Note:
Loading ...
Loading ...
Loading ...