Loading ...
Loading ...
Loading ...
Seffing Surface Burner Controls
e
LifE H!
Setting the Simmer / Regular / Power / Turbo Boil Burners
Operating the Regular Burner:
I. Place cooking utensii on surface burner.
2. Push the surface control knob down and turn counterclockwise out of the OFF
position (See Figure I).
3. Release the knob and rotate to the LITE position.
Note: All four (or five) electronic surface ignitors will spark at the same time.
Howeve b only the burner you are turning on will ignite.
4. Vlsual[y check that the burner has a flame.
5. Once the burner is lit_ continue to turn counterclockwise to the desired flame
size. The control knobs do not have to be set at a
Figure I - Regular Burner
particular setting. Use the knob indicator settings
to adjust the flame as needed. DO NOT cook with
the surface control knob in the LITE position (The
electronic ignitor will continue to spark if the knob
is left in the LITE position).
Setting the Bridge Burner
LITE
Figure 2 - Bridge Burner
Setting the Bridge Burner
The Bridge Burner should be used with
rectangular shaped cookware. Cookware like
a cast-iron Griddle is designed specifically for
best results with the Bridge Burner.
The Bridge Burner feature may be used to combine the cooking power of 2
or if needed 3 gas surface Burners located along the left-hand side of the
cooktop. The left rear and left center Burners are controlled by the left rear
surface Control Knob. In addition the left front Burner may be added to the
Bridge Burner with the left front gas Control Knob.
Operating the Bridge Burner
1. Push the left rear surface control knob in and turn counterclockwise out
of the OFF position (See Figure).
2. Release the knob and rotate to the UTE position (See Figure). Note: All
electronic surface ignitors will spark at the same time. Howeve b only the
selected surface Burner will [ite.
3. Vlsua[[y check that the left rear Burner has lit.
4. Continue to rotate the gas control knob counterclockwise past the first LO.
5. Visually check that both the left rear and left center Burners are lit.
6. When both burners are lit, continue to turn the control knob
counterclockwise to adjust to the desired flame size for both burners
together. Note: The markings between the 2nd HI and LO settings on the
left rear control knob before adjusting the flame size for both burners.
7. Add the left front Burner if needed. Once lit, visually adjust the flame size
of the left front Burner to match the flame size of the Bridge Burner.
DO NOT cool< with any of the surface control knobs in the LITE position (The
electronic ignitor will continue to spark if the knob is left in the LITE position).
Note: If only the left rear surface Burner is needed_ adjust the settings
between the 1st HI and LO.
Note: The left front Burner may be added to the Bridge Burner by setting the
left front gas Control Knob.
10
Loading ...
Loading ...
Loading ...