Loading ...
ASSEMBLY INSTRUCTIONS – ELECTRIC HEATER
NOTE: To prevent breakage, unit is shipped without the element installed.
1. Check UL/CE label on Heater for proper voltage
2. Remove end plates.
3. Open element clips at each end of the Heater and carefully install the quartz tube. Re
move one nut from end of element. Slip on wire over element screw. Replace nut.
NOTE: Hold element ceramic rmly while tightening nut to prevent damage to element.
Nut should be tightened snug, a loose connection can cause element to fail.
Connect other side of element in like manner. Close element clips over tube.
4. Replace end plates.
5. Clean tube and reector with alcohol or equivalent.
6. Snap on protective grill provided.
WIRING INSTRUCTIONS
1. Remove cover plate from junction box.
2 Attach conduit.
3. Use copper or aluminum wire suitable
for 90°C.
4. Replace cover plate.
5. Observe local electrical code
regulations.
OUTDOOR INSTALLATION
1. Heater must be mounted with reector
angled down.
2. All electrical connections must be in
compliance with the National Electric
Code and local codes for outdoor
wiring.
3. Use only wiring components UL/CE
listed for outdoor use with IP X4
minimum rating
WARNING
Unit may be a source of possible shock
Unit may be a source of possible ignition, maintain required clearances to all combustibles
Never block the front panel of the Heater
Do NOT operate within 25 feet of ammable/explosive material
NEVER attempt to service Heater without disconnecting its power source
This appliance is not intended for use by young children or inrm persons unless they
have been adequately supervised by a responsible person to ensure that they can use the
appliance safely.
Young children should be supervised to ensure that they do not play with the appliance.
Do not use if the heating element is damaged.
The heater must be installed at least 7’ (2.1 mm) above the oor.
A means for disconnection of the appliance must be incorporated in accordance with the
local wiring codes.
Loading ...
Loading ...
Loading ...