Loading ...
Loading ...
Loading ...
8
1886
Installing the Bulbs and Glass
ON
T
urn P
o
w
er
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass Remote CradleRemote
Lift the globe and align the
notches in the globe retainer
with the tabs in the light kit.
Assembling the LIght Kit
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Lift the globe assembly and attach it to
the upper switch housing using the three
thumbscrews, found in the hardware bag.
Tighten all three screws securely by hand.
3 of 3
Thumbscrew
BAG
Partially install two light kit screws, found in the
hardware bag, halfway into the motor housing as shown.
It does not matter which two screw holes you choose.
1
STEP
2
STEP
Connect the plugs from the fan and
light xture. Make sure to line up the
colored markings on the connectors.
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise. Install the
third light kit screw. Tighten all screws securely.
3
STEP
2 of 6
Light Kit Screw
BAG
1 of 6
Light Kit Screw
BAG
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose.
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Turn the light kit counterclockwise until the
light kit screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
4
STEP
5
STEP
6
STEP
2 of 6
Light Kit Screw
BAG
1 of 6
Light Kit Screw
BAG
Loading ...
Loading ...
Loading ...