Loading ...
Loading ...
Loading ...
PelPro Pellet Stove • 7083-801C • October 28, 2019pelprostoves.com
27
Replacement Parts
Replacement Parts
REV
REVISIONS
A RELEASED
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
Snap Disc
1. Turn the dial control to the off position. Unplug the
power to the unit.
2. Using #2 Phillips screwdriver, loosen the bolts on the
rear of the unit holding on the left side panel. You do
not need to remove the screws. Remove side panel
by lifting up and out.
3. Locate the snap disk on the top side of the feed tube
where it meets the hopper. Disconnect the wire leads
from the snap disk.
4. Using a #1 Phillips screwdriver, remove two 6-32
fasteners retaining the snap disk onto the side of the
feed tube.
5. Using the same fasteners, attach the new snap disk.
Attach the wire leads.
6. Restore power.
Replacement kit: SRV230-0080
Igniter
1. Turn the dial control to the off position. Unplug the power to the unit.
2. Unplug the wire leads to the igniter.
3. Loosen the thumb screw in the side of the igniter chamber.
4. If there is difculty in removing the igniter from the chamber, the chamber can be removed
from the rear of the rebox by removing the 1/4-20 bolt.
5. Re-install the new igniter into the chamber. Ensure igniter ange it ush with back
of chamber.
6. Tightening the thumb screw.
7. Re-attach wire to terminals.
Replacement kit: SRV7000-660
Loading ...
Loading ...
Loading ...