Loading ...
Loading ...
Loading ...
MAINTENANCE REQUIREMENTS
CHECK FOR DAMAGED OR WORN PARTS
Check a Sears Service Center for repHacement of dam-
aged or worn parts.
NOTE: It is normaH for a small amount of oiHto appear
under the saw after the engine stops. Do not confuse this
with a HeaMngoiHtank.
• STOP Switch - Ensure STOP switch functions properHy
by moving the switch up to the STOP position. Make sure
the engine stops; then restart engine and continue.
• FueHTank - Do not use saw if fueHtank shows signs of
damage or Heaks.
OiHTank - Do not use saw if oiHtank shows signs of
damage or Heaks.
CHECK FOR LOOSE FASTENERS AND PARTS
• Chain Brake Nuts
• Chain
• MuffHer
• CyHinder ShieHd
• Air Nter cover
• HandHeScrews
• Vibration Mounts
• Starter Housing
• Front Hand Guard
AiR FILTER
CAUTION" Never operate saw
• without the air filter.
Dust and dirt wil be drawn into engine and
damage it. Keep the air filter clean.
1. Remove the top cover (A) by loosening the cover
retaining screws. Cover will lift off (Fig. 31).
2. Clean air filter. Wash filter in clean, warm, soapy water.
Rinse in clear, cool water. Air dry completely.
NOTE: It is advisable to have a supply of spare filters.
3. Install air filter. Install engine / air filter cover. Make
sure cover fits properly. Tighten the cover retaining
screws securely.
B
A
Fig. 31
FUEL FILTER
Never operate saw
without the fuel filter.
The fuel filter should be replaced after each 10
hours of use. Drain fuel tank before changing.
To empty fuel tank before removing fuel filter.
1. Pull fuel filter (A) out of tank with a bent wire (B) or
long needle nosed pliers. Disconnect filter and discard
(Fig. 32).
NOTE: Do not pull hose completely out of tank.
2. Install a new fuel filter on hose and push hose and fil-
ter assembly back into tank so filter is positioned in
front right corner.
3. Fill tank with fresh fuel/oil mixture. See Of and Fuel
information. Install fuel cap.
B
Fig. 32
18
Loading ...
Loading ...
Loading ...