Crosley CRSE233TB0 Side by side Refrigerator

Use & Care Guide - Page 20

For CRSE233TB0.

PDF File Manual, 27 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
20
Locating the Filter
Yourrefrigeratorisequippedwithawater
lteringsystem.Thewaterltersystemlters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightside
of the refrigerator compartment.
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system.
Systemscertiedforcystreductionmaybe
used on disinfected waters that may contain
lterablecysts.
Test & certication results:
Rated Capacity - 200 gallons/757 liters for
PureSource 3
TM
iceandwaterlter
Ratedserviceow-.50gallonsperminute
Operating Temp.: Min. 33°F, Max. 100°F
Maximum Rated Pressure - 100 pounds per
squareinch
Recommended Minimum Operating
Pressure:30poundspersquareinch
To replace your PureSource 3
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker.
2 Removethelterbypushingontheend/
faceofthelter.
3 Slidetheoldwaterltercartridgestraight
out of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into the
lterhousinguntilitstopsagainstthesnap-
in connector at the back of the housing.
5 Push rmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at
thelterhousing.Anyspurtsandsputters
that occur as the system purges air out of
the dispenser system are normal.
7 Afterllingoneglassofwater,continue
ushingthesystemforaboutfour minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button
on the Ice & Water Dispenser control
panel for three seconds. When the display
changes from “Red” to “Green,” the
status has been reset.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisit
our online store at www.frigidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersat
least once every six months.
Herearetheproductnumberstorequestwhen
ordering:
PureSource 3
TM
Water Filter
Part #WF3CB
Replacing the Water Filter
In general, you should change the water
ltereverysixmonthstoensurethehighest
possiblewaterquality.Water Filter Status
on the user interface prompts you to replace
thelterafterastandardamountofwater
(200 gallons/757 liters for PureSource 3
TM
)
hasowedthroughthesystem.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lterbeforereinstallingtherefrigerator.
Filter Cartridge
The PureSource 3
TM
ice and water
ltersystemistestedandcertied
to NSF/ANSI Standards 42 and 53
forthereductionofclaimsspecied
on the performance data sheet.
More about your Advanced
Water Filter
CHANGING THE FILTER
Loading ...
Loading ...
Loading ...