Loading ...
Loading ...
Loading ...
ASSEMBLY
HOW TO ASSEMBLE YOUR BLOWER
WARNING:
Stop the engine before opening the vacuum
inlet door or attempting to insert or remove
the vacuum tubes. The engine must be
stopped and the impeller blades no longer
turning to avoid serious injury from the
rotating blades.
BLOWER TUBE ASSEMBLY (Fig. 1)
• Locate the two locking tabs on the side of the blower
tube.
• Align the grooves on the nozzle with the locking tabs on
the blower tube and push the nozzle onto the blower
tube,,
• Turn the nozzle clockwise until the parts snap into place
and are firmly tightened,
• Align grooves on the blower tube with locking tabs in the
blower outlet (inset) and push the blower tube into the
blower outlet.
° Turn the blower tube clockwise until the parts snap into
place and are firmly lightene&
Locking Tabs
Blower
Outlet
Grooves
Blower Tube ',,
Flare Nozzle \\
LockingTabs
Grooves
VACUUM BAG ASSEMBLY (Fig. 2 & 3)
• Open the zipper on thelarge end of the vacuum bag.
° insertthe elbow tube, groovedend first, through the zip-
per opening in the vacuum bag.,Then, push the grooved
end of the elbow tube through the vacuum bag tube
opening in the other end of the vacuum bag,,Make sure
the vacuum bag tube opening is flush against the tube
flange,.
• Close the zipper on the vacuum bag.,Make sure the zip-
per is closed completely and the zipper seam is tucked
toward the inside of the vacuum bag,
Grooved End
Elbow Tube
/
Vacuum \
Bag Tube Zipper
Opening Opening
Figure 2
Vacuum Bag
Recessed Tube Opening
Tube Flange
Right
Figure 3
Figure 1
Loading ...
Loading ...
Loading ...