Loading ...
Loading ...
Loading ...
Cool Down Period
For safe food storage, allow 24 hours for the appliance to cool
down completely before loading with food. The appliance will
run continuously for the first several hours. Do not place any
food in the appliance until after the first 24 hours of operation.
Thermostat Setting
The appliance is shipped from the factory with the thermostat
set at about the mid-point of the operating range. Adjustments
colder or warmer can be made after the appliance has
been running for at least 8 hours. Allow at least 8 hours for
temperature stabilization before re-adjusting the thermostat.
Defrost Setting
The appliance is designed to defrost automatically every 12
hours. To set the time of defrost, wait until the desired time to
defrost. With the notch on the timer knob aligned with the line
on the bracket (Fig. A), turn the defrost timer knob clockwise
slowly. The timer will click several times, then once loudly,
at which point the defrost cycle begins. The timer knob will
advance through the defrost cycle, then click loudly at the end
of the cycle. The appliance will defrost automatically every 12
hours after the first defrost cycle.
For example, to set the appliance to defrost at 10:00 AM, turn
the timer knob clockwise at 10:00 AM until the timer clicks
loudly. The appliance will defrost daily at 10:00 AM and again
12 hours later at 10:00 PM. NOTE:The appliance interior
temperature will rise slightly during the first defrost cycle.
Insulation
The insulated space of this cabinet is sealed to maintain peak
efficiency. Holes drilled in the cabinet may destroy that seal and
damage electrical wiring located in the insulated space.
DAMANGED ELECTRICAL WIRING OR WET INSULATION
CAUSED BY DRILLING WILL VOID THE WARRANTY.
Appliance Start-up
Once the appliance has been located in its permanent location
and the proper power and grounding has been provided, the
following items must be checked or completed:
Figure A
Features
e
e
e
e
e
e
e
e
e
e
e
e
e
Heavy duty epoxy powder coated adjustable shelves
NSF certified top mounted evaporator
2-Y2"urethane foam cabinet insulation
Torsion spring door closer
Heavy duty fixed and swivel casters
17 watt fluorescent lamp
Stainless steel evaporator housing
Removable stainless steel drain cover
Adjustable temperature control
NSF certified interior
Heavy duty front grill
Heavy duty commercially rated elecrtrical harness
Heavy duty removable stainless steel shelf support
Shallow
Regular
BoSom
This appliance is provided with four shelves; one goes on the
floor of the cabinet and the other three are placed in the metal
side supports, wherever they are needed. The shallow shelf
goes in the upper position
Casters
The appliance comes with four casters; two with locks for the
front of the unit and two without locks for the back of the unit.
The casters allow you to move the unit to it's final destination
with ease. The casters can then be locked into place. (Refer to
pages 3-4 for instructions.)
Adjustable Temperature Control
The adjustable cold control is located on the top left side
of the evaporator housing inside the unit. "5" is the medium
(recommended) setting and "9" is the coldest setting.
NSF Certified Temperature Gauge
This appliance is equipped with an NSF certified temperature
gauge to display cabinet internal temperature. The temperature
gauge is located on the top right side of the evaporator housing
inside the unit.
Loading ...
Loading ...
Loading ...