Loading ...
Loading ...
Loading ...
Features
Placethe front bar under
the lip of the lint screenopening
End of Cyde Signal
A signal will sound atthe end of the cycleand periodically during PressSaverat the
volume levelselected. (somemodels)
Drum Light (some models)
A drum light will come on whenever the door is opened to illuminate the dryer
drum during loading and unloading. Closing the door turns off the light.
Reversible Dryer Door
Your dryer is equipped with a reversible door. The door (an be hinged on the
right or left side. Refer to the INSTALLATION INSTRUCTIONSfor directions
on changing the door.
Drying Rack (some models)
Use the drying rack to dry items which should not be tumble dried.
I. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Placethe front bar under the lip of
the lint screen opening.
3. Place items to be dried on top of the rack. Weight should not exceed 10
Ibs. Leave space between items, but do not let items hang over the sides
or through tile grids. Do not tumble other items when using the drying
rack.
4. Select Timed Dry. Useonly the Air Fluff/No Heat option for items containing
plastic,foam rubber, rubberdike materials,feathers or down.
5. When items are dry, remove the ra(k and replace the lint screen. If lint
screen is not in place, tumbling items could enter the exhaust system and
cause damage to tile dryer.
Common Drying Problems
Marly drying problems involve poor (leaning results, poor soil and stain removal, residues of lint and scum, and fabric
damage. For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM
Greasy, oily
stains
Lint
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkfing
POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES
• Fabric softener sheet _ Rub fabric softener stains with bar _ Add a few bath towels to small loads for
soap, Rinse and rewash proper tumbling
• Overloading
Overdrying causes static
electricity_
• Lint screen not clean
when cycle began
Lint is attached to "pills."
Some "silkdike" fabrics should be air
dried
, Use proper drying temperature
Place fabric softener sheet on top of load
before starting the dryer.
Do not overload dryer,
Use fabric softener in washer or dryer to
reduce static electricity.
Remove items when they are slightly
damp to avoid overdrying
Check that lint screen is clean and in
place,
Reduce load size and rewash using
liquid fabric softener in the final rinse
, Or, add a fabric softenersheet and
tumble without heat
, Uselint brushor roller to remove lint
e
Pilling is normal with
synthetic and permanent
press fabrics_ This is due
to abrasion from normal
wear.
Use a lint brush or shaverto remove
pills_
Use fabric softener to lubricate fibers,
, When ironing, use spray starch or fabric
finish on collars and cuffs,
e Turn items inside out to reduce abrasion,
Overdrying
Overloading
• Leaving items in dryer
after cycle ends,
Irreversible condition,
o
o
e
Reduceload size and tumble at
medium or low heatfor 5-10 minutes_
Remove items immediately Hang or
fold. 6
Follow fabric care label directions,
If shrinking is a concern, check load often,
Remove items while slightly damp and
hang or lay flat to complete drying.
Block knits into shape.
Do not overload dryer_
Remove items as soon as cycle ends
Loading ...
Loading ...