Loading ...
Loading ...
Loading ...
NSTALLAiTION INSTRUCTIONS 29
Insfallafion fesf (Duel)
Once you have completed the installation of the dryer,
use this test to make sure the condition of the exhaust
system is adequate for proper operation of the dryer.
This test should be performed to alert you to any serious
problems in the exhaust system of your home.
. Your dryer features FLOW SENSETM, an innovative
sensing system that automatically detects blockages
and restrictions in dryer ductwork. Keeping ductwork
clean of lint buildup and free of restrictions allows
clothes to dry faster and reduces energy use.
!]@ NOTE -,
he dryer should be cool before starting this test. If
e dryer was warmed up during installation, run the
R DRY cycle for a few minutes to reduce the interior
mperature.
2
To activate the Installation test:
1. Remove the drying race and literature, and then
dose the door.
Do not load anything in tile drum for this test, as in
may affect the accuracy of the results.
4. Checkthe displayfor results.
During the two minute test cycle, monitor the FLOW
SENSETM display on the control panel. If no bars
are displayed, when the cycle ends, the exhaust
system is adequate. If the exhaust system is severely
restricted, the display will show four bars.
Other problems may also be shown with error codes.
Refer to the next page for error code details and
solutions.
m
NO BARS: FOUR BARS:
OK RESTRICTED
Four bars indicates that the exhaust system is severely
restricted. Have the system checked immediately, as
performance will be poor.
S. End of cycle.
At the end of the test cycle, _ will display.
The test cycle will end and tt_r will shut off
automatically after a short delay.
2. Press and hold the SIGNAL ON/OFF and TEMP.
CONTROL buttons and then press the POWER
button. This button sequence activates the
installation test. The code _ will display if the
activation is successful.
3. Press START/PAUSE button.
The dryer will start the test, which will last about
two minutes. The heat will be turned on and the
temperatures in the drum will be measured.
Loading ...
Loading ...
Loading ...