Loading ...
Loading ...
Loading ...
Conversion Kit
7
WARNING
FIRE HAZARD
- Use a soapy solution to check that it is leak-tight.
- Never test for gas leaks with a match or other flames.
- Failure to follow this instruction can result in death or fire
6)
Follow these instructions to leak test the appliance:
Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections
indicate a leak. If a leak appears, shut off gas valve controls and adjust connections.
Then check the connections again.
NEVER TEST FOR GAS LEAKS WITH A MATCH OR OTHER FLAMES.
Remove all of the detergent solution from the cooktop.
Electronic Ignition System - initial lighting
Cooktop burners use electronic igniters rather than standing pilots. When the cooktop
control knob is pushed in and turned to the minimum flame " " position, the system lights a
spark to ignite the burner. This sparking continues until the control knob is turned to the
desired setting.
7)
Check the operation of the cooktop burners. Push in and turn each control knob to the maximum flame
position ( ). The flame should light within 4 seconds.
If the burners do not light properly, turn the control knob to the O position. Make sure that the burner cap
is in the proper position. Make sure that the power supply cord is plugged in and that a circuit breaker or
house fuse has not blown. Make sure that the shut-off valve is in the "ON" position. Check operation
again. If a burner does not light at this point, contact your SMEG dealer for assistance.
Loading ...