Loading ...
Loading ...
Loading ...
Hot Water
For optimal cleaning and drying results, hot water
is necessary° The incoming water temperature
shouJd he 120" F (49 ° C) to properJy activate the
detergent and meJt greasy food soiJso
To check the incoming water temperature, turn on the
hot water faucet nearest the dishwasher and Jet it run
into a glass in the sink. Place a candy thermometer in
the glass and check the temperature once it has
stopped rising.
Add recommended amount of detergent to either side
of the Main Wash compartment as shown and close
the detergent lid.
Use a detergent designed specifically for use in an
automatic dishwasher. Be sure it is fresh. Store
granular detergent in a cool, dry place (not under the
sink).
Recommended Amount
Too little detergent results in poor cleaning, hard water
filming/spotting and poor drying. Too much detergent
can cause permanent etching!cJoudines&
The amount of detergent to use is determined by the
hardness of the water and soil level of the load. Refer
to the f@Jowing chart for detergent usage
recommendations.
Light Soil 5 teaspoons
Soft (0-4 gpg} Normal Soil 6 teaspoons
Heavy Soil 8 teaspoons
Light Soil 7 teaspoons
Medium (5-9 gpg} Normal Soil 8 teaspoons
Heavy Soil 10 teaspoons
Light Soil 9 teaspoons
Hard (10-12 gpg) Normal Soil 10 teaspoons
Heavy Soil 12 teaspoons
*Ybur local water utility or state university extension service can tell
you the degree of water hardness in your area,
Un extremeJy hard water conditions (13 grains per
gallon or more*), it is difficuJt to achieve good
resuJts with any dishwasher. A mechanicaJ water
softener may be necessary to improve water
quality, detergent effectiveness, and protect the
dishwasher parts from the damage that hard
water can cause°
Do not use detergent with the Rinse OnJy cycle.
Leave the detergent lid open when running Rinse
Only.
Rinse Aid
Regular use of a rinse aid improves drying,
reduces spotting and filming, and reduces
moisture melt on the dishwasher interior.
An automatic rinse aid dispenser is located next to the
detergent cup.
The window next to the dispenser cap indicates when
the rinse aid reservoir needs to be refilled. When the
level of rinse aid is below the indicator marks and the
window is nearly dear, it is time to refill the dispenser.
Check the dispenser monthJy.
To add rinse aid to the
dispenser: turn the cap
counterclockwise to open.
Remove the cap and pour i
liquid rinse aid into the
opening. The amount of
rinse aid dispensed during
the cycle is adjustable by moving the lever inside the
reservoir area. For most water conditions use the
manufacturer recommended setting of "2". Adjust it up to
the "MAX" setting for hard water. Set the lever anywhere
between these amounts as needed to get the best results.
Replace the cap and turn it clockwise to close.
Loading ...
Loading ...
Loading ...