Loading ...
Loading ...
Loading ...
InsideCleaning (Aggressive)
In cases where the clean washer cycle along with care
and cleaning of rubber gasket folds isn't done, and severe
odor, mold, mildew, or residue buildup have developed,
follow the below cleaning procedure to help alleviate the
problem.
CLEANING PROCEDURE - Washer Drum
Ensure the wash tub is empty (or no clothes toad),
Open the detergent drawer and pour eight (8) cups of
bleach into the detergent compartment. Select dean
washer cycle as described previously in Inside Routine
Cleaning (Preventive).
Upon cycle completion inspect the interior of the
washer to see if the odor/residue has been eliminated.
If any additional cleaning is required, repeat the above
procedure. This may take several cycles depending on
the severity of the odor/residue. You may observe some
remaining discoloration due to the long term effects of
this residue.
For especially contaminated areas visible inside the drum
(including the front rubber seal), these areas might be
more effectively cleaned by spraying a Bleach Cleaner on
a scrub brush, soft sponge, or towel and scrubbing.
Always wear rubber or latex gloves and protect floor
If odor is still left after bleach cycle(s) and bleach cleaner,
open the detergent drawer and pour one (1) pouch
of TIDE ®WASHING HACHINE CLEANERin detergent
drawer. Select system clean cycle as above and start
the washer.
@
o
o
o
@
®
@
®
®
®
st_
®
o ® @
®
@ o
@
® ® o
Press and hold both for ten seconds
to enter system clean cycle.
See Inside Routine Cleaning (Preventive) for
future cleaning maintenance which is necessary to
avoid repeating issues.
If the clean washer cycle is cancelled or paused
during the cycle, the washer will go through 2 rinse
cycles to clean the drum of any residual bleach before
unlocking the door.
Loading ...
Loading ...
Loading ...