Loading ...
Loading ...
3
NOTE:
This appliance has been fully function tested prior to packaging.
No adjustment is required or available to the user.
No installation is required apart from connection to gas and electrical supplies. (Fig. 1)
IMPORTANT SAFETY INSTRUCTIONS
DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS
APPLIANCE
DO NOT OPERATE WITH PANELS, COVERS OR GUARDS REMOVED FROM THIS APPLIANCE
DO NOT OPERATE IN A BATHROOM OR BEDROOM
DO NOT OPERATE IN AN UNVENTILATED ROOM
DO NOT OPERATE IN A ROOM WITH A VOLUME LESS THAN THAT SHOWN IN THE TABLE
BELOW
DO NOT CONNECT TO AN U.L.P GAS CYLINDER LOCATED IN DOORS
MINIMUM ROOM SIZE PER MODEL
MODEL
OAGCH25 (25MJ/h)
OAGCH15(15MJ/h)
ROOM VOLUME (NG or ULPG)
37.5m
3
62.5m
3
DO NOT spray aerosols near this heater while it is in use. Most aerosols contain butane gas which can be a fire
hazard if used near this heater when it is in operation.
DO NOT get the remote controller wet or expose it to direct sunlight. DO NOT place containers of liquid on the
appliance. Water spillage can cause extensive damage to the appliance and create an electrocution hazard.
DO NOT unplug the heater while it is in operation or while the fans are still cycling, or it may damage the
appliance.
DO NOT unplug the power when turn off the heater after use. The fan will keep cycling for 3 minutes until stop.
DO NOT move the heater while it is in operation or while the fans are still cycling.
When the heater is operated for the first time or after long periods of non use a slight odour may be emitted, this is
normal. However if the odours persist after switching off the appliance, please contact the service center.
Loading ...
Loading ...
Loading ...