Loading ...
Loading ...
Loading ...
Engaging Turbo mode:
What is the purpose of Turbo Mode? It enables the compressor to run at a higher speed,
therefore achieving faster cooling to your nominated temperature.
Step 1: Press the button once to turn on. The light will illuminate green to indicate that
Turbo Mode is engaged.
Step 2: To turn o, press the button again. The green light will now go out to indicate that
Turbo mode is no longer engaged.
Change temperature between °C or °F:
Step 1: Press the
button 2 times for single zones or 3 times for dual zones.
Step 2: Use the
and
button to change between °C or °F.
Step 3: Once you reach your desired setting you do not need to press any further buttons.
Just leave it sit until you see the setting ash 5 times – this means the setting is now locked in.
Turn o one zone – only for Dual zone models:
Turn on and o LEFT zone (the zone with step inside): Press and hold the
button for 3 seconds.
Turn on and o RIGHT zone (the large deep zone): Press and hold the
buttonfor 3 seconds.
Setting Battery Protect:
Step 1: Press the
button 3 times for single zones or 4 times for dual zones.
Step 2: Use the
and
button to choose either HI, MED or LO protection levels.
Step 3: Once you reach your desired setting you do not need to press any further buttons.
Just leave it sit until you see the setting ash 5 times – this means the setting is now locked in.
12v Input 24v Input
Unit turns o at Unit turns on at Unit turns o at Unit turns on at
LO: 10.1 11.1 21.5 23.0
MED: 11.4 12.2 22.5 24.0
HI: 11.8 12.6 23.0 24.5
Automatic shut down and re-start voltage levels:
NOTE:
• When o, there will be NO LED temperature display in the correlating zone.
• You CAN NOT turn o single zones through the App, this must be done directly on the unit.
page 5
CCP FRIDGE·FREEZER
LED Control Panel & Operation Instructions
Loading ...
Loading ...
Loading ...