Loading ...
Loading ...
Loading ...
Filter Performance Data Sheet
Model Number ADQ72910902
Use with replacement cartridge ADQ72910902
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration Jess than
equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42.
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine, Taste and
Odor and Nominal Particulate Class I.
Intluent Challenge Product Average % NSF Max. Min. %
Contaminant Reduction Average concentration. Units Reduction Effluent NSF Test
Intquent Water Reduction Reduction
apply to each row, Requirements mcj/L
Particulate Class I Particle At least 10000
5600000 833333 93.2 _>85% 470000 91.6 511032-03
size: >0.Sin to <lore particles/ml
Chlorine taste and odor 1.9 mg/L 2.0 mcj/L _+ 10% 0.05 mcj/L 97.4 _>50% 0.05 mcj/L 97.4 511031-03
° To a capacity of 300 gallons (1135 L).
° Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines / Water Supply Parameters
Water pressure 30 - 100 psi (207 - 689 kPa)
Water temperature 33°F - 100°F (0.6°C - 37.8°C)
Service flow 0.5 gpm (1.9 Ipm)
To reduce the risk associated with ingestion
of contaminants due to use with water that is
microbiologically unsafe or of unknown quality.
Do not use with water that is microbiologicaily unsafe or
of unknown quality without adequate disinfection before
or after the system.
Systems must be installed and operated in accordance with
manufacturer's recommended procedures and guidelines.
To reduce the risk of property damage due to water
leakage:
° Read and follow Use instructions before installation and
use of this system.
° Install on COLD water lines only.
* Company with all state and local plumbing codes. Never
install or operate where inlet water pressure may exceed
125 psi (862 kPa).
" Protect filter from freezing. Remove filter in temperatures
below 34°F (1°C).
" Replace cartridge at specified service interval. Cartridge
MUST be replaced at least every 6 months.
° After replacing the water filter cartridge, dispense 2.5
gallons (9.46 liters) of water to purge the system,
depressing and releasing the dispenser pad in cycles
of 30 seconds ON and 60 seconds OFF. Discard the
purged water.
To purchase a replacement filter r visit your local Sears store
or call 1-800-4-MY-HOME ®. Visit us on the web at
www.sears.com
Product distributed in the United States by Sears Brands
Management Corporation, Haft:man Estates, IL 60179.
23
Loading ...
Loading ...
Loading ...