Loading ...
Loading ...
Loading ...
Connect Vent
1. Using a 4 in. (10.2 cm) clamp, con-
nect vent to exhaust outlet in dryer. If
connecting to existing vent, make sure
the vent is clean. The dryer vent must
fit over the dryer exhaust outlet and
inside the exhaust hood. Make sure
the vent is secured to exhaust hood
with a 4 in. (10.2 cm) clamp.
2. Move dryer into final position. Do not
crush or kink vent. Make sure dryer is
level
Complete Installation
1. Check to be sure all parts are now
installed. If there is an extra part, go
back through the steps to see which
step was skipped.
2. Check to be sure you have all of your
tools.
3. Dispose of all packaging materials.
4. Check the dryer's final location. Be
sure the vent is not crushed or kinked.
5. Check to be sure the dryer is level.
(See "Level Dryer.")
6. Plug into a grounded 3 prong outlet.
Turn power on.
7. Remove the blue protective film on
the console and any tape remaining
on the dryer.
8. Read "Dryer Use."
9. Wipe the dryer drum interior
thoroughly with a damp cloth to
remove any dust.
10. Set the dryer on a full heat cycle (not
an air cycle) for 20 minutes and start
the dryer.
If the dryer will not start, check
the following:
• Dryer is plugged into a grounded 3
prong outlet.
• Electrical supply is connected.
• House fuse is intact and tight; or
circuit breaker has not tripped.
• Dryer door is closed.
11. When the dryer has been running for
5 minutes, open the dryer door and
feel for heat. If you do not feel heat,
turn the dryer off and check to see if
the gas supply line shutoff valve
is open.
• If the gas supply line shutoff valve
is closed, open it, then repeat the
5-minute test as outlined above.
• If the gas supply line shutoff valve
is open, contact a qualified
technician.
16
Loading ...
Loading ...
Loading ...