Loading ...
EOS Page 2 / 3 05/2022
ASSEMBLY
Ensuring the spacers face inward, [Figure 1] align the bolt holes
of Outside Screens (B2) over Outside Screen (B1). [Figure 2]
Loosely secure the screens by hand-tightening M6x12mm Bolt
Sets (D). [Figure 3]
IMPORTANT: HAND-TIGHTEN ONLY as over-tightening will
NOTE: If mounting holes are not aligning, try switching which
screen is on top to see if holes align better. Light force may be
required to align holes.
STEP 1
Figure 5
Spacer
Figure 1 Figure 2
Figure 3
Figure 7Figure 6
Align the bolt holes of Inside Screens (A2) over Inside Screen
(A1).
Loosely secure the screens by hand-tightening M6x12mm Bolt
Sets (D).
IMPORTANT: HAND-TIGHTEN ONLY as over-tightening will
STEP 2
NOTE: If mounting holes are not aligning, try switching which
screen is on top to see if holes align better. Light force may be
required to align holes.
Install one Handle (E) onto each screen by hand-tightening
M6x12mm Bolt Sets (D). [Figure 4]
Fully tighten all bolts on both sets of screens, then fully tighten
the handle hardware. [Figure 5]
STEP 3
Figure 4
Double check that all bolts are securely fastened. [Figure 7]
The bolts used to secure the hinges should be loose enough to
allow the screen to open and close, but tight enough so the nut
STEP 5
With both handles facing upward, place outside screens (B)
over inside screens (A). Connect the screens by fastening
M6x25mm Bolt Sets (C). [Figure 6]
STEP 4
NOTE: There will be a space between the two screen halves
to provide adequate opening/closing clearance.
Completed Screen
IMPORTANT:
Read all use, care and safety information
before using this product.
Loading ...