Loading ...
Loading ...
EN EN
Pg 3 of 11
4305P OM | Part No: 950-0597-001 | Rev 1.0
© 2022 HARMAN International Industries, Incorporated. All rights reserved.
4. General Placement / Set-up
Room Placement
Position each speaker in a vertical orientation with the tweeter on the top. The speakers should
be placed so the listening position and the two speakers form an equilateral triangle.
On the back of the Primary speaker, set the bass contour switch based on the speaker's
proximity to side boundaries such as walls, inside a bookcase / cabinet, or on floor stands.
Recommended Bass Contour settings
When positioned away from side boundaries or on a stand set to 0dB.
When positioned close to side boundaries or when the speaker is inside of a cabinet or
bookcase set to -3dB.
On the back of the Primary speaker, set the L/R Assign switch to identify the Primary speaker
based on your selected positioning.
Speaker System Set-up
1. Make sure AC Main switch is set to Off.
2. Connect the provided AC cords between the AC Inlets on the back of both speakers and the other end to your home AC outlet.
3. Connecting the Primary Speaker to the Secondary Speaker:
a. Hardwired: Attach one end of the supplied CAT6 cable to the Digital Link connector on the back of the Primary speaker and
the other end to the Digital Link connector on the back of the Secondary speaker. Maximum CAT5 cable length 23' (7m). This
will deliver the highest level of audio quality at 192kHz / 32bit between the two speakers. Both speakers Power LEDs will
illuminate solid Yellow when tethered together.
b. Wireless: Each pair of 4305P have been pre-paired for wireless connectivity at the factory. Maximum distance between
speaker should be 30' (9m) or less. Maximum audio quality through wireless connection is 96kHz 24bit. Both speakers Power
LEDs will illuminate solid White when connected wirelessly.
i. Wireless Note: If for some reason the speakers in this system become un-associated from each other follow the
following steps:
1. Verify both speakers are On.
2. On the back of the Secondary speaker, Press and Hold the Sync button for >3 seconds. The Power LED will
illuminate and flash Yellow color.
3. On the back of the Primary speaker, Press and Hold the Sync button for >3 seconds. The Power LED will illuminate
and flash Yellow color.
4. When association is successfully completed, both Primary and Secondary speaker Power LEDs will Illuminate solid
Green.
4. Turn the volume down located on the Primary speaker.
5. Set the AC main switch on the back of both speakers to On.
Note: When powered up, the system will boot-up, indicated by all LEDs on the front panels flashing White. Once the boot-up process
is completed, the system automatically enters an initial network setup mode.
BASS
CONTOUR
0dB
-3dB
BASS
CONTOUR
0dB
-3dB
L/R
ASSIGN
L
R
Loading ...
Loading ...
Loading ...